Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VIC2-2FXO & power

Hello,

we would like to connect an old paging system to our CCM 6.1 system. So we have a FXO port on a 2811 router connected to this paging system. The paging system is currently configured with something called "power provided externally" (translated from German, not sure what the proper technical term is). In principle it is the FXO port that should provide the power, which is strange. As a reconfiguration of the paging system requires soldering, is it possible to configure the FXO port to provide power?

Regards,

Christoph Gartmann

1 REPLY
Hall of Fame Super Gold

Re: VIC2-2FXO & power

No, you need an FXS port to interface that system.

147
Views
0
Helpful
1
Replies