Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VIC2-2FXS at Cisco 2811 ISR, is NM-HDV2 needed?

Hello,

I have a Cisco 2811 router that is configured as CUCME and working OK. So I need to connect a fax machine so I decided to take FXS card, but I don't know if I need to find NM-HDV2 to get VIC2-2FXS working on 2811, or it works at any of HWIC slots... I have FXO (VIC2-4FXO) working w/o any network module (installed at HWIC slot), so do I need such for FXS?

P.S.: I have PVDM2-8 installed in the router, will it be enough?

Thank you.

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: VIC2-2FXS at Cisco 2811 ISR, is NM-HDV2 is needed?

The NM is not needed.

The PVDM that you have is enough.

1 REPLY
Hall of Fame Super Gold

Re: VIC2-2FXS at Cisco 2811 ISR, is NM-HDV2 is needed?

The NM is not needed.

The PVDM that you have is enough.

1460
Views
5
Helpful
1
Replies