08-25-2006 03:17 PM - edited 03-13-2019 02:45 PM
Hi All;
I am using two CME that connected to two different service provider. I am trying to have video conferencing (VT advantage) by these two CME when I dial from one phone to the other phone, but video is no working. I turned off the firewall but still video is not showing anything. very appreciate if you can solve this problem.
thanks
Alex
Solved! Go to Solution.
08-25-2006 06:18 PM
You need to enable H323 slow start for video to work.
voice class h323 1
call start slow
voice service voip
supplementary-service h450.12 advertise-only
## this command is required to preserve video calls over a h323 trunk.
telephony-service
video
maximum bit-rate 384
service phone videoCapability 1
create cnf
ephone 10
video
dial-peer voice 1 voip
destination-pattern <>
session target ipv4:
voice-class h323 1
show call active video to verify the call info.
HTH
Sankar
PS: please remember to rate posts!
08-25-2006 06:18 PM
You need to enable H323 slow start for video to work.
voice class h323 1
call start slow
voice service voip
supplementary-service h450.12 advertise-only
## this command is required to preserve video calls over a h323 trunk.
telephony-service
video
maximum bit-rate 384
service phone videoCapability 1
create cnf
ephone 10
video
dial-peer voice 1 voip
destination-pattern <>
session target ipv4:
voice-class h323 1
show call active video to verify the call info.
HTH
Sankar
PS: please remember to rate posts!
08-29-2006 06:15 PM
Alex,
So did that help ? Is video working or still having issues ?
Sankar
08-30-2006 08:20 AM
Hi Sankar;
very appreciate that was very helpful and video is working now without problem. Also I already rate your suggestion.
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: