Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

viewing ToS byte with debug or other utility

Is there any way that I can determine if ToS is being used on packets using the debug features of router based IOS? If not, what else could I use?

Thanks,

Diego

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: viewing ToS byte with debug or other utility

Diego,

Are you using a LLQ CBWFQ policy? Typically you would need to for voice. If so a "show policy interface X/X" would show the counts for the queues.

To simply test for TOS bits, you could use an access list to match on TOS, apply it as an access-group on the appropriate interface, then show access-list to see the counts.

access-list 101 permit ip any any tos 5

access-list 101 permit ip any any tos 3

access-list 101 permit ip any any

interface e0/0

ip access-group 101 out

show access-list 101

2 REPLIES
Blue

Re: viewing ToS byte with debug or other utility

Diego,

Are you using a LLQ CBWFQ policy? Typically you would need to for voice. If so a "show policy interface X/X" would show the counts for the queues.

To simply test for TOS bits, you could use an access list to match on TOS, apply it as an access-group on the appropriate interface, then show access-list to see the counts.

access-list 101 permit ip any any tos 5

access-list 101 permit ip any any tos 3

access-list 101 permit ip any any

interface e0/0

ip access-group 101 out

show access-list 101

New Member

Re: viewing ToS byte with debug or other utility

I had no idea I could use the tos parameter in an ACL. I am only used to using eq www and eq telnet. I guess that I should use the ? command more ;)

Thanks,

Diego

108
Views
5
Helpful
2
Replies
CreatePlease to create content