I have AS5400 voice gateway. The setup is , there are T1's lines incoming ,
and multiple leased lines connecting to the WAN. Voice calls from the T1 will be landing on AS5400 , EIGRP is enabled over the WAN.
Apart from of EIGRP load balancing packet by packet , is there a way , where we can direct one voice call (comming from T1s) on one Leased line and the next call on the other leased line (without Gate Keeper).
You can create multiple dial peers with the same destination pattern. The router will hunt on those dialpeers, randomly/sequentially. Each dial peer can point to a differnt ip address for its session target. Each Ip address can be routed through a differnt leased line. Its sort of a hack but it will work for your scenario.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...