Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Voice & Data on the same T1

I have the follwoing scenario:

My service provider offers me a fractional T1 service with 10 voice ports and 8 data ports (512K) for Internet access. I have an MRP3 on a ICS7750 with a VWIC-1MFT-T1 port and the IOS with the FW/IPSEC feature set.

My question is the following: Can I take the T1 from the provider and connect it to the VWIC-1MFT-T1 port and use it for voice and data? Can I use the channel-group and the ds0-group on the same controler? Are there any limitations to this configuration?

Thanks

Gabriel

1 REPLY
New Member

Re: Voice & Data on the same T1

There is no limitaions to configuring both ds0 and channel-groups. Questions to ask provider is what type of signaling or isdn switch type to use ( pri-group timeslots 9-18). Here is an example using ds0.

controller T1 1/0

framing esf

linecode b8zs

cablelength short 133

channel-group 1 timeslots 1-8 speed 64

ds0-group 2 timeslots 9-18 type e&m-wink-start

!

voice-port 1/0:2

output attenuation 3

echo-cancel coverage 32

echo-cancel suppressor

no comfort-noise

timeouts interdigit 2

!

dial-peer voice 1 pots

preference 1

destination-pattern 9T

port 1/0:2

104
Views
0
Helpful
1
Replies