Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voice gateway on 2811 sends h225 call setup in q931 protocol

We are trying to connect a Voice Gateway on 2811 with IOS c2800nm-entservicesk9-mz.123-11.T3.bin, through FWSM with ver. 2.3.3

To Cisco Call Manager ver. 4.1.3

Trace of the traffic shows, that the router, sends the h.225 call setup in protocol q.931, which the firewall does not allow in it's H.323 Inspection Engine.

The Firewall issus message no.:

405104

Error Message %PIX-4-405104: H225 message received from outside_address/outside_port

to inside_address/inside_port before SETUP

Is there any way to force the router to send the initial setup request in the correct protocol h.225, or are we forced to find another IOS which handles this the right way.

And in case of IOS change, is there anyone that can recomment an IOS that works in a simmular environment.

2 REPLIES
Cisco Employee

Re: Voice gateway on 2811 sends h225 call setup in q931 protocol

The problem could be that the Setup message is being dropped due to segmented packets. If this is the case then you can try the command "ip tcp path-mtu-discovery" to the 2811 to allow for larger packet size.

Kevin

New Member

Re: Voice gateway on 2811 sends h225 call setup in q931 protocol

Hello Kevin

Thanks for the input, but I Seriously doubt, that, that, could be the problem.

We are able to send packets with 1500 bytes size, throug our network.

By the way, the setup works, when the gateway resides on a 1760 router. !!!

139
Views
0
Helpful
2
Replies
CreatePlease login to create content