I need to sizing a voice gateway for an IP telefony provider. He has an Ip PBX asterisk in G729 codec and want to comunicatte with PSTN with 4 E1 in G711 codec. The gateway would have to make trascoding of 120 channels.
I think in an Cisco2800 solution but I found the DSP problem with this solution.
I need aid to make the gateway sizing since never I had one of this size.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.