Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VOICE INTERFACES

have an Cisco MC3810 router with 4 E&M analog interfaces ( Type 5 - 4 wire ) that are connected to an PBX and are configured for use in a VoFr connection.

Is it possible to configure a connection like this ( VoFr) changing the 4 E&M analog interfaces to an E1 controller ?

Thank you.

Renato Ribeiro

Rio de Janeiro - Brazil

1 REPLY
Cisco Employee

Re: VOICE INTERFACES

Yes, but if I am not mistaken, the 3810 only supports E1 QSIG. I am not sure if it supports E1 R2 now, you might need to use a different platform. Check the IOS release notes for the 3810.

94
Views
0
Helpful
1
Replies
CreatePlease to create content