I have configured a pilot number with two port witch are registred with the callmanger (publisher)automaticly. The ip address of these port begin with 169 (not in the same subnet). The DNs are in the same partition that others phone, i can't dial the voice mail pilot number while i can dial the DN of these port !!!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.