This is intended as more of a suggestion than a discussion.
In white paper for "Voice-Over-IP Gateway", the specific network modules associated with the Cat6000/Cat4000 used for providing Voice gateways are listed, but for the Cisco 2600/3600, they are not specified. It would make that document much clearer and specific as the software/modules evolve.
In the future, note there is a "Feedback" button on the bottom of each document on the TAC website you can use to make such suggestions. Providing this feedback through their interface routes your suggestion directly to the engineering team in charge of that particular document automatically.
They would like you to fill one out for the particular document you were referring to so they can get it updated.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...