I recently upgraded to Unity 184.108.40.206, TSP 3.0(2) and CM 3.1(1). The system is configured with 8 voice mail ports that are configured to forward to the next port on busy and no answer(Ports 611-618). Before the upgrade everything worked fine. After the upgrade, the forwarding no longer worked. I made sure the configuration in "service parameters" for voice mail was correct and forwarding was set right in the voice mail port. What is weird is that when I configure the ports to start at 612 rather than 611, everything is fine. Forwarding works. It's like 611 does not worked. Does anyone have any suggestions??<br><br>
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...