cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
664
Views
0
Helpful
6
Replies

voice port not appear in running-config

arianto.wibowo
Level 1
Level 1

Hi all,

I have problem with my C3660.

I want to configure this router as voice gateway.

But unfortunately, my voice port doesn't appear when I type "sh run".

But it is detected when I issue command "sh ver" and "sh diag".

My voice modul using 4 PORT Voice PM for MARs Port adapter (2FXS and 2FXO).

Thanks for any help.

ari

6 Replies 6

paolo bevilacqua
Hall of Fame
Hall of Fame

Are there the DSP on the NM ? Check show diag.

I'm using this module

Slot 3:

High Density Voice Port adapter

Port adapter is analyzed

Port adapter insertion time unknown

EEPROM contents at hardware discovery:

Hardware Revision : 1.1

Top Assy. Part Number : 800-XXXXX-01

Board Revision : G0

Deviation Number : 0-0

Fab Version : 02

PCB Serial Number : JABXXXXXXXX

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 00 CC 41 01 01 C0 46 03 20 00 0D EF 01

0x10: 42 47 30 80 00 00 00 00 02 02 C1 8B 4A 41 42 30

0x20: 35 34 36 30 43 4E 42 03 00 81 00 00 00 00 04 00

0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

WIC Slot 0:

T1 (1 Port) Multi-Flex Trunk WAN Daughter Card

Hardware revision 1.0 Board revision A0

Serial number 27XXXXXX Part number 800-03568-03

Test history 0x0 RMA number 00-00-00

Connector type PCI

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 20 01 00 01 9F DA 68 50 0D F0 03 00 00 00 00

0x30: 50 00 00 00 01 11 08 00 FF FF FF FF FF FF FF FF

HDV firmware: Compiled Mon 26-Nov-01 16:24 by miriyala

HDV memory size 524280 heap free 202857

Seems like there are no DSP on it.

For sure no FXS/FXO ports.

Kindly find sh diag attachment

I have same 2 devices (Router 3660), one is work, but not for the other.

What IOS feature set are you using? Are they feature sets or versions different between the top routers?

Using c3660-ik8s-mz-122-6c-M1.bin for both

Seems like the problem is on NM voice module (2V).

What do you think ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: