Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

voice translation-rules

hi guys

I have a problem in the configuration of the voices translation-rule

can someone help me?

my problem and that I have a line in entry (PRI) with did to two digit and internally I have three digit 5xx while the external number is actually 3989005xx to here nesun problem for the operation.

But I don't succeed in making to visualize the whole number in exit included theinside number

on the debug isdn is proposed the whole number, but I don't understand because is not visualized.

I have planned this configuration but not sò if it is correct

!

voice translation-rule 50

rule 1 / ^ \ (. * \) / / \1 / type unknown unknown

rule 2 / ^ \ (. * \) / /0\1 / type national national

rule 3 / ^ \ (. * \) / /00\1 / type international international

!

voice translation-rule 51

rule 1 / ^5 \ (.. \) / /3989005\1 /

!

voice incoming translation-profile

translate calling 50

!

voice translation-profile uscenti

translate calling 51

!

voice-port 0/0/0:15

translation-profile incoming entranti

local-alerting

cptone IT

bearer-cap Speech

!

dial-peer voice 20 potses

translation-profile outgoing uscenti

destination-pattern 0.T

port 0/0/0:15

!

dial-peer voice 10 potses

translation-profile incoming insert-zero

incoming called-number 3989005..

direct-inward-dial

no register e164

!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: voice translation-rules

Hi,

You have asked this question already, beside for many would be hard to understand "nesun problem" :)

Check that sometime TI doesn't allow outgoig DID and you have to request they do.

1 REPLY
Hall of Fame Super Gold

Re: voice translation-rules

Hi,

You have asked this question already, beside for many would be hard to understand "nesun problem" :)

Check that sometime TI doesn't allow outgoig DID and you have to request they do.

241
Views
0
Helpful
1
Replies
CreatePlease to create content