Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voicemail problem when using 'Messages' button.

I have unity build 2.4.6.126 installed, but the problem is that when you hit the 'messages' button on the ip phone, it tries to dial the first voicemail assigned # (eg 7000). However, if this port is in use, it is configures (in ccm) to roll over to the next available port (eg 7001). However, it does not attempt to dial the next available port, but simply tries the first listed port of 7000, and returns a busy signal until it is free. If you manually dial 7001, it works ok.

I've tried deleting the voicemail ports on ccm 3.1(1) and recreating them, but to no avail. I'm going to upgrade the TSP on unity, but am not sure if there something else worth checking?

Regards

Azam

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Voicemail problem when using 'Messages' button.

It sounds like the Cisco Voice Messaging Interface is installed and running on CCM. This isn't needed for Unity. Try disabling it.

3 REPLIES
Cisco Employee

Re: Voicemail problem when using 'Messages' button.

It sounds like the Cisco Voice Messaging Interface is installed and running on CCM. This isn't needed for Unity. Try disabling it.

New Member

Re: Voicemail problem when using 'Messages' button.

Thanks for the info. I'll give it a go.

New Member

Re: Voicemail problem when using 'Messages' button.

Sorry for the delay in replying.

You were exactly right. The CMI service was running on the CM. I disabled it, and everything started working fine.

Thanks again for your help.

132
Views
5
Helpful
3
Replies
CreatePlease login to create content