Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VOIP-Analogue-FXO and FXS -

http://www.cisco.com/warp/public/788/signalling/fxo_disconnect.html#3

-- Note: Cisco Moderator edited above url to point to a publicly veiwable document in an effort to widen audience. --

Please see the above url case 3 :

I have a job involves ,2 7206 vxr are conneted via E1 and pabx on both ends,using the voip access now.

but the customer wishes to connect FE0 form 7206 to 1751v routers and connect to FXO -

OTHER END IS FXS.

COULD THIS WORK ?

regards

2 REPLIES

Re: VOIP-Analogue-FXO and FXS -

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources online at http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Cisco Employee

Re: VOIP-Analogue-FXO and FXS -

Hello -

The analog signalling is not end-to-end, so as long as you have an FXS device connected to the 1751 router's FXO port, this shouldn't be a problem. Keep in mind there are issues with answer supervision and supervisory disconnect with FXO ports, search CCO for more information on how to address those.

Regards,

Clay

119
Views
0
Helpful
2
Replies
CrearPor favor para crear contenido