cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
389
Views
0
Helpful
2
Replies

voip config

sk
Level 1
Level 1

hi

i have a two sites,which i have to connect for voice and data connectivity.

i have fxs interfaces on both sides.

how do i configure both routers for voice can anybody provide sample.

and how do i assign the phone numbers of the two phone lines.

and as far as i know we cannot connect more than two phones on one fxs so what should i do if i have to connect 3 phones on one side .do i have to go in for a fxo?

all help would be highly appreciated

thanx in advance

Pravash

SK International

2 Replies 2

net-sol
Level 1
Level 1

Hello Pravash,

The config is simple, lets draw a diagram for simplicity.

Ph----FXS(Router1)---------WAN---------(Router2)FXS-----ph

111 -------------------------------------------------------------------- 221

112 -------------------------------------------------------------------- 222

[ Dont worry about -------- its just to fill the space ;) ]

Router1

dial-peer voice 111 POTS

destination-pattern 111

port (depends on router)

!

dial-peer voice 112 POTS

destination-pattern 112

port (depends on router)

!

dial-peer voice 22 voip

destination-pattern 22.

session target ipv4:192.168.1.2

!

Router2

dial-peer voice 221 POTS

destination-pattern 221

port (depends on router)

!

dial-peer voice 222 POTS

destination-pattern 222

port (depends on router)

!

dial-peer voice 11 voip

destination-pattern 11.

session target ipv4:192.168.1.1

!

Sites can also call each other locally. For 3rd phone you have to connect another FXS port. FXO port can be connected to PBX and then you have to dial the particular extension to get the line.

!

HTH

ngundura
Level 1
Level 1
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: