Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VOIP Configuration ?

Im new person to VOIP, but I have knowladge to do VOIP. I need to know

configartion (Modular Parts) of 3640 Router to do the VOIP (Terminating)

using 12 Analog Lines. Pls send me the deatils to verify with myself

Thank You

Sivalee R Dissanayake

1 REPLY
New Member

Re: VOIP Configuration ?

The 3640 router has 4 slots and each slot can take up to 4 analog ports. So if you need 12 analog ports, you will use up 3 of the 4 available slots. The network module which houses the analog card is called NM-2V it has DSPs to process the voip calls and it has 2 VIC slots. Then you need to decide what TYPE of analog module you need. The options are: E&M, FXS, FXO.

You can populate the network module in anyway that you wish. There is some info on the NM-2V below:

http://www.cisco.com/warp/customer/788/products/hw_voice_net.html

The other hardware is below:

E&M:

http://www.cisco.com/warp/customer/788/products/2em_vic.html

FXS:

http://www.cisco.com/warp/customer/788/products/2fxs_vic.html

FXO:

http://www.cisco.com/warp/customer/788/products/2fxo_vic.html

Hope this helps.

109
Views
0
Helpful
1
Replies