Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Voip debug commands

Setup: PSTN - GW - GK - CCM

When I place a call from PSTN I get dead air. Using 'debug isdn q931' I see the call comes in to GW and shows as connected. What debug commands should I run on GK to see if the call is coming thru GK? I'm not looking for debugging registration. GK, GW, and CCM registration is fine. I just want to see if the call is coming in and out of GK.

Thanks a lot.

1 REPLY
Green

Re: Voip debug commands

Hi,

debug h225 asn1 displays H225 (RAS and Q931 call setup) messages.

debug cch323 h225 displays H225 call setup messages

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a0080094ac3.shtml#comm

HTH

//G

221
Views
0
Helpful
1
Replies
作成コンテンツを作成するには してください