I would like to look at both your complete configs and show ver. Then, make sure you have a dial peer to accept incoming calls and use the right codec on that. If you do not configure an incoming dial peer, we use the default dial peer with with you cannot specify your parameters such as codec etc.
Then, send me
debug ccsip messages
and one of below:
debug vpm signal (if the pots leg is E&M/ FXO/FXS)
debug vtsp all -this is verbose (if the pots leg is cas)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.