Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VOIP dialpeer digit mismatch

I am terminating calls using a cisco mc3810 my outbound pots call leg is good the calls are passing through, but when i do a show call history voice bri it only shows the tag number of my outbound pots dialpeer and shows pid0 for the incoming voip dialpeer i have used different combinations for answer address destination pattern incoming called number but nothing works can anyone shed some light on this

thanks

2 REPLIES
Silver

Re: VOIP dialpeer digit mismatch

Check this out for the configuration example:

http://www.cisco.com/warp/public/788/AVVID/config_h323_ccm.html

Silver

Re: VOIP dialpeer digit mismatch

The incoming voip peer will be matched based on :

1) answer address matching the ani of the call

2) incoming called number matching the dnis of the call

3) ani matching destination pattern of the dial peer

Incoming called-number . will matchg all calls to a single incoming voip dial peer.

Good way to check is to do a debug voip ccapi inout.

Taimoor

218
Views
0
Helpful
2
Replies
CreatePlease login to create content