I am looking for a voip gateway to install in a router to work with call manager 3.3. I do not want to use an 8 port E1 / cat6k module. I have both 3640 and 2600 series routers to work with. I have two small clusters in separate locations and need pstn access in each with voip between on a leased line and wish to implement toll bypass at a later stage, but main issue is minimise cost at startup. I have all other equiment except gateway for PSTN. Any suggestions anyone.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.