VoIP gateways on routers currently supporting VRFs
I've got an issue where a network has been setup using VRFs throughout and a VRF has been setup for Voice to remote sites. Although this works wonderful with CallManager they now want to use the router for ISDN breakout.
The problem is I can't see a way of configuring the gateway side of things to use the VoIP VRF rather than the underlying layer.
I've searched CCO and not found anything - anyone got any ideas?
I'd like to avoid routing voice on the underlying layer if possible.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...