I have two geographically remote sites , each with a Lucent Definity PBX, I'm getting a 2Mbps E1 circuit to connect the two sites and I have two 3660 routers to do this. I need to carry data and voice (50/50)and was considering the VWIC-2MFT-E1 for this. Does anyone know if this is possible and how I do it !.
I'm told that the PBX can connect Q931 but this is my first voice project !.
I know I can carry the leased 2Mbps line but am at a loss for the voice connection detail.
You need to find out what signalling types the PBX supports. Q931 (ISDN) is preferably the way to go. Also what kind of a card is in the PBX, a T1 or an E1. If it is an E1 and your Data is also an E1 then you can use the VWIC, but you need to put the VWIC in an NM-HDV, because the NM-HDV has the DSP's on board which are needed to transcode and pass over IP.
You can use one port on the VWIC for your data and the other port for the ISDN pri connection to the PBX.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...