We have 2 identical 3725 with aim-voice30 and e1-mft
We are configure simple "toll bypass" voip config with one 3725 and other router (1750, 2600, etc) connected by ethernet. 3725 connected to PBX (Avaya Definity) by E1 pri.
Config is very simple - 2 dial-peers on both routers. It's not my first voip config.
Problem: i try to call from one router to another, call is established (deb voip ccapi), rtp is send/received (debug voice rtp), phone numbers is displayed on the phone screen but no any audio - full silence.
If i try install ANY other router - all does working.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...