Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VoIP on a 2600 supported T1 and E1?

can a 2600 support VoIP on E1 and T1? What about VoFR?

Thank you

3 REPLIES
Cisco Employee

Re: VoIP on a 2600 supported T1 and E1?

The 26/3600s can support VoIP and VoFR using T1 and E1 telephony interfaces (NM-HDV + VWIC) configured for ISDN, T1 CAS and E1 R2.

Community Member

Re: VoIP on a 2600 supported T1 and E1?

In addition to what Clay mentioned, if you have a Cisco 2600 series, Cisco 3660 or Cisco 3700 series, you can also use the AIM Module and a VWIC-1MFT (or VWIC-2MFT) as well... This will free up NM Slot 1 to be used for something else. If you use the NM-HDV, it will have to go into slot 1.

Check out...

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t8/ft_04gin.htm#21054

Community Member

Re: VoIP on a 2600 supported T1 and E1?

Thank both of you!

124
Views
0
Helpful
3
Replies
CreatePlease to create content