Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VOIP on a 3660 with a CT1 PRI card

I have a 3660 that has a CTI PRI card in it...I can configure the controller part fine and the serial interface is created...but I don't get a voice-port. Is it possible to use this card as a connection to a telco provided PRI for outbound calls. I have done this in the past with MFT cards and would like to be able to use this extra equipment.

I have updated the ios and it doesn't appear to help...

Thanks,

Joe

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: VOIP on a 3660 with a CT1 PRI card

No, you cannot use the NM-1CT1 for voice.

You will need something like NM-HVD to support voice on the 3660, or AIM-VOICE-30 and VWIC card in an NM module.

Hope this helps, please rate post if it does!

1 REPLY
Hall of Fame Super Gold

Re: VOIP on a 3660 with a CT1 PRI card

No, you cannot use the NM-1CT1 for voice.

You will need something like NM-HVD to support voice on the 3660, or AIM-VOICE-30 and VWIC card in an NM module.

Hope this helps, please rate post if it does!

98
Views
0
Helpful
1
Replies