Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VoIP over Data Circuits

I have an Australian office & a office in New York connected via MPLS. I need to run voice between these 2 offices. Both these offices have 20 persons each. What do I need at both ends to make this work? Assuming that the HQ is in New York.

What hardware? Software? Phones?


Re: VoIP over Data Circuits

Depends on what phone technology you want to use. If you want to use Digital Phones/PBX solution is usually very expensive. You could go for a IP Telephony solution from Cisco. You will need a CallManager for call handling and Unity for Voice mail or Unified Messaging (Voice mail, email, fax all in your Inbox).

New Member

Re: VoIP over Data Circuits

Is there a low end call manager and unity solution? I was planning to use the soft IP phones. Do you think it will work with that?

Re: VoIP over Data Circuits

This may fit the bill.

Call Manager Express

Unity Express

Please remember to rate all postings that help you out.

CreatePlease to create content