Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VOIP question

I just got two FXS card for my 2611(64/16) and 2610(24/8), The IOS of 2611 is enterprise version. I connected 2611 and 2610 with the ethernet ports with a cross-over RJ45 cable and the ping is ok.

now when I want to configure the voice card, i use the following command,

2611#dial-peer voice 1 pots

desti 1111

next step, i should enter "port" command, but no "port" command, Why? is this a problem of IOS? or not.

thanks

2 REPLIES

Re: VOIP question

Under 'show ver' , do you see 2 FXS ports, etc?

Under 'show run' do you see voice-port like:

voice-port 1/0

...

voice-port 1/1

...

New Member

Re: VOIP question

The version you need is Plus so it should have been Enterprise Plus. Without the Plus image your routers will not recogonize the voice hardware.

Javed

91
Views
0
Helpful
2
Replies
CreatePlease to create content