Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VOIP Sample config

Dear All,

I have a scenario where i am using 2 routers each having 2 port FXS card. I am connecting both the routers back to back over ethernet port.

I want to connect FXS card on either end to PBX and place a voice call through PBX (I am not having E&M card to interface with PBX).

I would like to have a sample config for the same.

Router A having FXS card connected to PBX

Router B having FXS card conncted to PBX

Router A and Router B are connected back to back over ethernet interface over Cross UTP cable.

Sample configuration for interfacing FXS to PBX is required

1 REPLY
New Member

Re: VOIP Sample config

Lots of samples on CCO, here are a couple:-

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_configuration_example09186a00800afd65.shtml

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_configuration_example09186a008009431b.shtml

Remember that if you have FXS ports, your PBX must have FXO interfaces if you do not wish to use some form of converter for signalling conversion.

192
Views
0
Helpful
1
Replies
CreatePlease login to create content