without the chance of having the voice packets dropped by the be? All of the traffic shaping techniques involve containing ALL traffic to the CIR. Just wondering if I can burst the data traffic while leaving the voice without the possibility of bursting or getting dropped and yes, I understand that you can get two PVC's but this is all on one PVC.
Re: VOIP traffic shaping, any way to use above CIR?
What I read from the above is that traffic bounces between the minCIR and the CIR. Use minCIR when voice is being transmitted and use CIR when it is not. I'm missing something. How are we getting to the port speed?
Set the minCIR to the provider's CIR and the CIR to the Port Speed? Gotta be problems with that.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...