i have seen posts on this forum of success with doing ip phones thru a vpn. we have successfully accomplished this with a cisco router at each end. has anyone used netscreen devices for this? is there any reason why netscrren would not work? when we did it with the cisco routers it was just a gre tunnel however we would like to use ipsec. how does this affect the setup if at all.
this works very well. we are in the process of doing this to replace some frame relay links and i have a pilot set up that is working great. over a cable connection (10 miles away) i get ping responses of about 24 ms versus 10ms over the 768k(12 miles away) frame pvc from a desktop to the call manager. From another remote site with a 768k pvc i get 35-40 ms (250 miles away)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.