In the Data sheets of the SC2200, the Cisco's SS7 Interconnect for Access Servers solution, the SC2200 is shown outside of the PSTN and IP backbone. I would like to know that is this implemented at the Backbone side or the PSTN service provider?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.