I blew out a vsom stand vsms msp ru's so that I can have two stand alone boxes (both vsom & vsms on one box) one for lab and the other for production . .
One one box I am able to get it up and running on 6.3.2 on the other I have have created my raid0 drive and go to install and I keep getting an error message . . A profile for this machine could not be found . . (see pic) after which I enter the location of various partitions /dev/sda /dev/sdb /dev/sdc and it proceeds to the next step of creating partition plans and an error pops up and says "error while configuring partitions try again" . . I am unable to get the installation to complete . .
Has anyone seen this or know where I can go with this . .
I am trying to install on 5015B-MT, CIVS-MSP-1RU (where the vsom piece was originally) . . . Long story why I just didn't add the vsms part instead of blowing up
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...