Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VWIC-2MFT-E1= does not load firmware with 12.4(15)T1

Hi,

I have a VWIC-2MFT-E1= HW Rev 1.0 Board Rev B0 on a 2811 and I tried to load IOS 12.4(15)T1. I am getting an error message that the firmware could not load. I am reckoning that I have a HW problem but in case somebody has had similar issues there could be software problems too.

Any hint is appreciated.

Regards,

Mat

165
Views
0
Helpful
0
Replies