Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VWIC E1 and slips

I am using an AIM-VOICE-30 and a VWIC E1 (configured as a E1 (clock line , network, no-CRC) PRI ETSI ) in a 2651XM.

I am experiencing slips in the VWIC E1 controller. What should I do?

1 REPLY
New Member

Re: VWIC E1 and slips

Hi,

The reason is that by default the AIM is clocked on the internal PLL. Just add the following two command on the 2651xm (if VWIC in wic slot 0 of course)

network-clock-participate wic 0

network-clock-select 1 E1 0/0

The only problems I had on the issue was that fax calls were failing.

kind regards

Bart

138
Views
0
Helpful
1
Replies
CreatePlease login to create content