Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

vwic with AIM card

I have VWic-1MFT-T1 installed in WIC 0 slot as well as AIM-voice-30 installed on the motherboard of 2611XM router. What is the config for AIM to work so the T1 can start using those DSP resources. Also the network-clock-participate wic0 is the referring to AIM or Vwic-MFT-T1?

This is what i have so far:

network-clock-participate wic 0

network-clock-select 1 T1 0/0

4 REPLIES
Community Member

Re: vwic with AIM card

network-clock-participate wic 0

network-clock-participate aim 0 (slot#)

network-clock-select 1 T1 0/0

Community Member

Re: vwic with AIM card

Thanks for the response. I'm not able to see the second command with aim 0. Only option i have is wic or slot#. I'm running 12.2.15zj3 code. Please let me know what i'm missing.

Silver

Re: vwic with AIM card

The 2600 doesn't have the keyword as there is only one AIM slot so it is implicit that it is to be used as a DSP resource. You do need the keyword as there are multiple WIC slots. Make sure you also add the network-clock-select t1 0/0 keyword as well.

Community Member

Re: vwic with AIM card

Thanks. So all i need is network-select-clock t1 0/0 to make this work.

319
Views
0
Helpful
4
Replies
CreatePlease to create content