Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Walkie-talkie Box on VIC E&M card

Our customer wants to connect two I/O 4 wire voice boxes (it works as walkie-talkie)through IP cloud. This box is not capable to do any dialing. To place a call to far end you need press the mike button and start talking. I don't see how I can use "dial-peer voice xxx pots" and "destination pattern xxx" commands without using dial number. What commands should I use instead? Thanks.

Joseph

1 REPLY
New Member

Re: Walkie-talkie Box on VIC E&M card

Hi

Please check the information on this link. It should answer your question.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008015094e.shtml

Regards.

123
Views
0
Helpful
1
Replies