Want to disable automatic video mode on 8945 ip phones
I'm running on CUCM 8.5.1, CUPS 8.6.3, and using CUPC 8.5.5 with deskphone control of 8945 model, fw 9.2.2
When I call another 8945 phone, video is automatically started. We have no choice to do a simple audio call, escalating to video only if desired.
We can set the video transmission to "Mute" in the 8945 phoneset Menu -> Preferences -> Camera settings. Then at the beginning of the call, both parties have a mute video screen.
On the CUPC in deskphone mode, we only have the "Start Call" choice. "Start Video Call" is not available, because the Start Call choice is already considered as a video call choice, due to the 8945 ip phone behaviour...
Do you know if it's a design intent or if there's something in the roadmap to change this ?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...