Hi Lance,
Perhaps this wii help;
Bus Error Crashes
The system encounters a bus error when the processor tries to access a memory location that either does not exist (a software error) or does not respond properly (a hardware problem). A bus error can be identified through the output of the show version command provided by the router (if not power-cycled or manually reloaded).
These are two examples of bus error crashes:
Router uptime is 2 days, 21 hours, 30 minutes
System restarted by bus error at PC 0x30EE546, address 0xBB4C4
System image file is "flash:igs-j-l.111-24.bin", booted via flash
.........At the console prompt, this error message might also be seen during a bus error:
*** System received a Bus Error exception ***
signal= 0xa, code= 0x8, context= 0x608c3a50
PC = 0x60368518, Cause = 0x20, Status Reg = 0x34008002
From this doc;
http://www.cisco.com/en/US/products/ps5854/products_tech_note09186a008073dc12.shtml#bus_error_crashes
Troubleshooting Bus Error Crashes
http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_tech_note09186a00800cdd51.shtml
Hope this helps!
Rob