Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

What NM's are needed to connect to PBX?

I would like to send calls over my point to point T1 between two locations.

Can anybody tell me what Network Modules I need for the physical connection to the PBX's? I will use a 2600/3600 platform for my routers and a T1/PRI interface at the PBX.

2 REPLIES

Re: What NM's are needed to connect to PBX?

we use an nm-hdv-1e1-30 to connect to our pbx, if you are using t1's then i think you just change the part number to nm-hdv-1t1-24 (but you'll need to confirm that)

hope this helps

New Member

Re: What NM's are needed to connect to PBX?

I guess u did not tell it clearly. u are using the T1 connection to communicate with 2 end if so then u need another T1 or E1 card to terminate the voice date or tie up this to ur PBX system in this case u must ask to ur PBX expert that does the PBX system support the T1 or E1 ... or else if u need 4 circuite then u can go for E&M Card but in that case u need also the same E&M module for ur PBX system. any way .. best of luck

Regards

Minhaz

sminhaz@bnfcom.com

83
Views
0
Helpful
2
Replies