What type of QoS to be used for video conferencing and data on same T1?
In this scenario there is a T-1 between a 3660 and a 2611 that all data and video conferencing travel across. There are video conferencing problems if a large data file is being transmitted. What is the best QoS method for this.
Re: What type of QoS to be used for video conferencing and data
Video , Audio or Voice are constant stream of rtp packet and same QOS applies. The best way to gois to clasify all udp rtp packet in the real-tine application prt rangeand pre-allocate a certain amount of bandwidth to the video traffic.
Claculation of bandwidth used by codec :
[Codec Bandwidht used for video _ (1+ overhead/payload-size)] + additional 5 KB saftey margin.
interface serial 0/0:23
ip address 188.8.131.52 255.255.255.252
ppp multilink interleave
ppp multilink fragement-delay 10
ip rtp priority ip rtp priority 655535 16383 960
The above would queue any rtp packet ranging from video, voice or audion in a high PQ which will be dequeued (emptied) first before going to service data waiting
in the WFQ.
It is necessary to calculate the bandwidth require for one video confrecing session and multiply by x for the bandwidht reservation. x is the number of session that will be carried over the T1 link.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.