For Avvid , i.e ca;; manager the CAC is done using "location" and maybe "region" for calls admission
over Low speed WAN bandwidth.
Say you have two site A and B with call manager located in site A, you might say site A is in region 1 in a Lan location using
bandwidth of 100,000KB/s. Also put site B phones in region 2 and limited to the WAN bandwidth so we put
site B devices in location WAN using say 128KB of bandwidth.
If we used default codec for all phones, then at g711 using 80KB of bandwidth, only one call would be allowed to be connected over the wan link
by the call manager, because it deduct the bandwidth uses presently from that available 128 - 80 =48KB/s. No other calls is admitted on that bandwidth.
However here's were region comes in. You set all phone in region 1 to use g711 over LAN and g729 for communication with device in region 2 and vise-varsa the remote devices.
Now if a call is connected between region 1 device and region 2 device, g729 is used hence the bandwidth deducted is 26KB and we can still admit more calls at 26KB till the bandwidth left after each deduction can support one voice conversation.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...