Re: Whats does the state EM_PARK mean in E&M ports ?
There are a few reasons why you would see the status as EM_PARK. Typically if you would be running into an issue with the DSP's where they wont respond to the DSP manager, you would see the ports go into EM_PARK. Solution : Upgrade to a code greater than 12.2.6 to prevent the DSP's from timing out and staying in hung state. The other issue could be that after a call is released, the PBX would continue to sieze that channel and not do the release, and the router would eventually put the state of that port into EM_PARK. Solution : Fix the PBX so it releases the channel, or bounce the T1.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...