06-26-2002 02:16 PM - edited 03-12-2019 07:28 PM
Which command return this output ?
___DSP VOICE VP_ERROR STATISTICS___
Predict Conceal(ms): 4630, Interpolate Conceal(ms): 0
Silence Conceal(ms): 1280, Retroact Mem Update(ms): 0
Buf Overflow Discard(ms): 18670, Talkspurt Endpoint Detect Err: 119
___DSP VOICE RX STATISTICS___
Rx Vox/Fax Pkts: 1395439, Rx Signal Pkts: 0, Rx Comfort Pkts: 0
Rx Dur(ms): 27908670, Rx Vox Dur(ms): 27890120, Rx Fax Dur(ms): 0
Rx Non-seq Pkts: 0, Rx Bad Hdr Pkts: 0
Rx Early Pkts: 298, Rx Late Pkts: 703
06-26-2002 02:16 PM
The "show cdapi" command displays is used to get the output below
and it gives information about the call distribution application programming
interface (CDAPI):
The output does show the cdapi doing an active voice call.
06-27-2002 05:23 AM
You will get a similar if not identical output when you have:
term mon
and then do a
show voice call summ
and pick an active channel, say 2/1:1.1 (the whole channel id)
and then do
show voice call sum 2/1:1.1
!
This will show the call stats including all those DSP stats for that call. You have to have term mon, don't forget.
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide