07-03-2002 01:46 PM - edited 03-12-2019 07:44 PM
Which command return this output ?
___DSP VOICE VP_ERROR STATISTICS___
Predict Conceal(ms): 4630, Interpolate Conceal(ms): 0
Silence Conceal(ms): 1280, Retroact Mem Update(ms): 0
Buf Overflow Discard(ms): 18670, Talkspurt Endpoint Detect Err: 119
___DSP VOICE RX STATISTICS___
Rx Vox/Fax Pkts: 1395439, Rx Signal Pkts: 0, Rx Comfort Pkts: 0
Rx Dur(ms): 27908670, Rx Vox Dur(ms): 27890120, Rx Fax Dur(ms): 0
Rx Non-seq Pkts: 0, Rx Bad Hdr Pkts: 0
Rx Early Pkts: 298, Rx Late Pkts: 703
07-03-2002 01:46 PM
The "show cdapi" command displays is used to get the output below
and it gives information about the call distribution application programming
interface (CDAPI):
The output does show the cdapi doing an active voice call.
07-08-2002 07:32 AM
Also, you can see it from
term mon
show voice call summ (then if you pick a particular channel such as 1/1:1.2 and repeat the CLI)
show voice call 1/1:1.2
you will be able to see the above message as well.
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide