Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Which command return voice vp_error statistics ?

Which command return this output ?

___DSP VOICE VP_ERROR STATISTICS___

Predict Conceal(ms): 4630, Interpolate Conceal(ms): 0

Silence Conceal(ms): 1280, Retroact Mem Update(ms): 0

Buf Overflow Discard(ms): 18670, Talkspurt Endpoint Detect Err: 119

___DSP VOICE RX STATISTICS___

Rx Vox/Fax Pkts: 1395439, Rx Signal Pkts: 0, Rx Comfort Pkts: 0

Rx Dur(ms): 27908670, Rx Vox Dur(ms): 27890120, Rx Fax Dur(ms): 0

Rx Non-seq Pkts: 0, Rx Bad Hdr Pkts: 0

Rx Early Pkts: 298, Rx Late Pkts: 703

2 REPLIES
Anonymous
N/A

Re: Which command return voice vp_error statistics ?

The "show cdapi" command displays is used to get the output below

and it gives information about the call distribution application programming

interface (CDAPI):

The output does show the cdapi doing an active voice call.

New Member

Re: Which command return voice vp_error statistics ?

You will get a similar if not identical output when you have:

term mon

and then do a

show voice call summ

and pick an active channel, say 2/1:1.1 (the whole channel id)

and then do

show voice call sum 2/1:1.1

!

This will show the call stats including all those DSP stats for that call. You have to have term mon, don't forget.

Hope this helps.

175
Views
0
Helpful
2
Replies
CreatePlease to create content