Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Which things does one need to config on ea. node of a cluster?

Hi,

When there's a cluster of CallManager's, it appears that some items such as service parameters need to be set on each node of the cluster. Are service parameters the only things which should be configured on each node or are there many other settings which also need to be set on each node of a cluster. Also, for those settings which only need to be entered once, do they need to be entered on the publisher or can they be entered on any node in the cluster? Also, is there any place in any of the CM documentation or on TAC where this is directly addressed?

1 REPLY

Re: Which things does one need to config on ea. node of a cluste

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

86
Views
0
Helpful
1
Replies