Why am I seeing different byte sizes on the different ends of the VoIP calls?
I have an AS5300 and a 3640 that I am using for VoIP calls. When I do a "show call active voice" on each end of the call I am seeing different payload under the CodecBytes output. On the AS5300 (originating) side I am seeing the bytes that I have specified for the payload in the VoIP dial-peer. On the 3640 (terminating) side I am seeing the default payload side. I was under the impression that the payload side would be determined by the VoIP dial-peer on the originating side. And I have been unable to find anything on the CC0 site specifying how to set up my terminating side so that it will use the same byte size as my originating side. Is there anyway that I can do this or am I stuck with the terminating side using the default payload size? The reason I ask this is because with it configured this way I there is a large disparity in the number of packets inbound/outbound on this circuit.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...