Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

why can't the AS5350 verifiy the token with OSP(Signature not verified)

i had tested the OSP with C2610 and C3640.

it had been OK.

but with c3640 and AS5350 or c2610 and AS5350 is not.

when i dial from c3640 to AS5350, the AS5350 gave me the validate fails message for token(by debugging - Signature not verified) on AS5350.

i could not understand why AS5350 can't validate the token which had worked well between c2620 and c3640.

and surely the configuration is almost same with as5350 and c3640 and c2610.

i could not figure it out.

plz, help me

3 REPLIES
Silver

Re: why can't the AS5350 verifiy the token with OSP(Signature no

Hope you are using the right image on the 5350. Note that few feature set do not support OSP.

You can take a look at this table to verify if your image supports OSP

http://www.cisco.com/en/US/products/hw/univgate/ps505/prod_release_note09186a00800b4298.html#65301

New Member

Re: why can't the AS5350 verifiy the token with OSP(Signature no

thank your reply.

but,i had upgraded it from c5350-ik8s-mz.122-2.XB6.bin to c5350-ik8s-mz.122-2.XA.bin.

surely same problem on c5350-ik8s-mz.122-2.XA.bin

New Member

Re: why can't the AS5350 verifiy the token with OSP(Signature no

i figured it out.

different IOS version(12.1 and 12.2) was that reason.

AS5350 was 12.2.11T, C3640 or C2610 were 12.1.3T.

when i had upgraded the IOS of c2610 or c3640, from 12.1.3T to 12.2.11T

the problem was gone away.

thank you.

99
Views
3
Helpful
3
Replies